Back to Guides
Guide

What Is a Pullback Trading Strategy?

What a pullback trading strategy is, the method in three steps, one rule written tightly enough to test, and how to tell a pullback from a reversal.

A pullback trading strategy enters in the direction of an established trend while price is temporarily moving against it, and depends on the trend resuming afterwards. The method has three parts: decide the trend by a written rule, mark the zone you will buy or sell into before price reaches it, and act on a single trigger when it gets there.

One judgement decides it, whether the move against the trend is a pause or the end of it, and the published tests for that disagree with each other. So the rule you trade has to be one you wrote tightly enough to check, and then measured yourself.

What is a pullback in trading?

A pullback is a brief pause inside a trend, after which the trend continues. Capital.com says: "A pullback is a brief pause in a trend." In an uptrend that is a temporary dip, also called a retracement, with the broader direction unchanged.

Capital also draws the contrast: "A pullback is temporary, whereas a trend reversal is permanent and marks the end of the existing trend." Keep that sentence, because the word reversal gets used the other way round elsewhere.

Capital's page also separates simple from complex pullbacks, which matters before you call a rule broken. A simple pullback is "a single-wave move", sharp and quick, that reaches a level and turns. A complex one takes more than one leg, and a depth test can pass on the first leg and fail on the second.

Pullback or reversal: how do you tell?

There is no single published answer. Four tests are in circulation and they do not agree.

TestSourceWhat it asks
A four-question checklistCapital.comDepth under 50% of the last move, a major level respected, volume down during the counter-trend move, and the last higher low or lower high not broken
A depth bandStrike.moneyPrice pulls back 20-62% against the trend, often to 38.2%, 50% or 61.8%, a trendline, or the 20 or 50 EMA
A structure rule on its ownStrike.money's comparison tableA pullback "Does not break major highs/lows"; a reversal "Breaks key structure (higher lows/lower highs)"
No threshold at allBenzingaIt calls a pullback "a temporary reversal in the prevailing trend", so depth is never quantified

Capital states its checklist as something you can apply, four questions:

  • "Depth: is the correction shallow (less than 50% of the last move)?"
  • "Key Level: is a major support/resistance level respected?"
  • "Volume: did volume decrease during the counter-trend move?"
  • "Structure: was the last major higher low/lower high broken?"

Capital then states: "A pullback confirmation is when the answer to the first 3 questions is a 'yes' and to the last question is a 'no'."

Strike.money's band is a different claim rather than a refinement of the same one: "Wait for the price to pull back 20-62% against the trend, often to Fibonacci levels (38.2%, 50%, or 61.8%), trendlines, or moving averages like the 20/50 EMA." Its floor and its ceiling both sit outside Capital's single number, so a 60% retracement passes Strike's test and fails Capital's. Your own record on your own symbol settles it.

Watch the word reversal while you read around. On Capital's page a pullback and a reversal are opposites. On Benzinga's, a pullback is itself "a temporary reversal in the prevailing trend". Here it means the end of the trend, in Capital's sense.

What a test costs to check matters too. A percentage test is the cheapest: you need the last swing's start and end, and arithmetic, and anyone can verify it afterwards. A structure test needs the last swing marked before the move happens, or you will decide in hindsight which low was the major one, and hindsight always finds the answer that makes you right. A volume test adds a data requirement, though a workable one: the ChartLabs chart legend shows each bar's volume, and a Volume indicator can be added from the Indicators menu into its own pane under price. The worked rule leaves volume out anyway, so that one thing moves at a time.

How do you trade a pullback, step by step?

Trend first, zone second, trigger third, and one trigger rather than four.

  1. Decide the trend by a written rule. Higher highs and higher lows, a moving average rule, or a trendline. Strike's own first step is to identify the primary trend "by using price action, higher highs and higher lows, or moving averages".
  2. Mark the zone before price gets there. A level, a trendline, a moving average, or a retracement band, chosen from the rule in step 1 and drawn in advance.
  3. Pick one trigger, and only one. Strike's entry note stacks four confirmations at once: a reversal candlestick pattern, a chart pattern, support or resistance, and an indicator reading. As a rule to test that is unusable, because you never learn which of the four did the work.

Written tightly enough to test, the whole thing fits in three sentences. Trend: the last two swings are higher highs and higher lows on the 1 hour chart. Zone: price retraces between 38.2% and 61.8% of the last swing, the two named Fibonacci levels inside Strike's band. Trigger: the first 1 hour candle that closes back above the 20 EMA while price is in that zone. Those are testable because someone who is not you could apply them to the same chart and reach the same answer. "Pulls back to a level" could not.

Change the depth band, the timeframe or the trigger and you have a different strategy, which is why only one of them moves at a time.

Which pullback method should you test first?

Pick one from a list and test it alone. Galen Woods' page treats pullback trading as a family of methods rather than one rule, and it names ten in three groups.

Price action and lines: trend lines and channels, John Hill's trend line method, and a pullback to a 50% retracement. Moving averages: a candlestick with a moving average, Al Brooks' two-legged pullback to the moving average, a weighted moving average with a Hull moving average, and the 9/30 setup. Other indicators: Linda Raschke's Holy Grail setup using ADX, an RSI hidden divergence, and pullback zones drawn with Heikin Ashi.

Each of the ten is a complete rule on its own, so test one, record it, then start the next in a separate strategy, where the two records cannot mix.

What is the win rate of a pullback trading strategy?

Nobody can hand you one that applies to your trading, and we publish no win rates.

A win rate belongs to one set of rules, on one market, over one period, with one set of costs. Move the depth threshold from 50% to 60% and the rules are different. Change the symbol, the timeframe, the trigger or the spread and they are different again. Any figure that reaches you has had all of that stripped off it, so it describes a strategy you are not trading.

Measure your own, on data you had not seen, with your own costs applied.

Which indicators do people use for pullbacks?

Moving averages, trendlines and retracement levels, with a longer tail on the method pages.

Strike.money names the 20 and 50 EMA, and the Fibonacci levels 38.2%, 50% and 61.8%. Woods' list adds four moving-average methods, ADX, RSI divergence, a Hull moving average and Heikin Ashi plots. Trendlines and channels appear on both.

The 50% level is in it by convention and is not a Fibonacci ratio. And the retracement levels are the subject of their own topic, so here they are only a way of drawing the zone in step 2.

Does a lower timeframe help the entry?

It is a reasonable thing to test and a poor thing to assume. Strike.money's advice is to "Use a lower timeframe, such as 15 min, for precise entry", while judging the trend on a higher one. Two timeframes mean two rules, and the lower one needs its own written trigger, or you have given yourself permission to find an entry whenever you want one.

Benzinga's worked example runs the same way round, on an assumed support level at 1.135 that the page flags as an assumption rather than a reading of the market. Treat a borrowed level the same way. The equities versions of this setup, taught on broker education pages, carry the same structure and different instruments, so their examples do not transfer to forex, indices, commodities or crypto without retesting.

Pullback or breakout at the same level?

Two entries can use the same level on different evidence. A breakout entry acts when price leaves the level. A pullback entry acts when price returns to it. One is early and often wrong, the other is late and sometimes misses the move entirely, and which is which depends on the market you are in.

Do not run both rules at the same level at the same time without recording which is which, or your result is the average of two strategies.

How do you test a pullback rule without fooling yourself?

Step forward bar by bar so the outcome is unknown when you enter. On a finished chart every pullback looks obvious, because you can already see that the trend resumed.

In ChartLabs that means replaying cleaned data from Dukascopy a bar at a time with the next bar hidden, and historic trades snap to candle boundaries and respect the chart's timeframe. Your timezone setting changes the times shown, not how bars are grouped. Around it:

  • Write down why you took the trade at the time. The Notes column in the Orders panel and the note button on the chart while a trade is open both do that, and notes come through in the CSV export. It makes "pause or reversal" answerable later instead of remembered.
  • Record the ones you did not take. A pullback rule that sat out six weeks of a trend has told you something, and a record of entries only will hide it.
  • Apply costs before you read anything. Commission and slippage are set per symbol and flow into every trade's P&L, balances and analytics.
  • Keep an untouched stretch for last. Analytics split by Training and Verification sessions, so the data you tuned on stays separate from the data you did not.
  • Review closed trades on the chart rather than in a list. The selected trade stays put and its row is highlighted, so you can ask whether the entry really met the sentence you wrote.

Then compare the two depth tests on your own sample, 50% against the 20-62% band, and see which one your symbol paid for.

Test one pullback rule properly

A pullback rule is cheap to write and easy to believe, and a record built on history you had not already seen separates the two. Manual backtesting is where that record comes from, and the beginner's guide walks the process end to end. For pair-specific behaviour and session effects, see the forex backtesting guide.

ChartLabs is one plan at $20 a month, with a 7-day free trial and no credit card required: start your free trial.

Related Topics

pullback-tradingtrend-tradingtrading-strategiesmanual-backtestingpullback-or-reversal